brushless motors LiPo batteries electronic speed controllers inrunner Motors outrunner motors HiTEC Transmitters and Receivers servos

The Fixed Wing
Electric Flight Specialists

<<<  Back
Tel: 01256 782 512
Email us 
Click here to Check us out on Facebook and to get access to special offers and notifications of new releases

20A ESC (Brushless Electronic Speed Controller)

PP-TESC20AU Brushless ESC

Please Click for a larger image


Please Click for a larger image

Share on your Facebook Page


Constant Current 20A
Burst Current 23A for 10 Seconds
Input Voltage Range 2-4 LiPo (6 - 16.8V DC)
BEC Voltage Range 2-4 LiPo (6- 16.8V DC)
BEC Output 5.5 DC @ 3A (3-5 mini servos)
Weight (g) 19g (includes all wires)
Size (mm) 48mm x 24mm x 10mm (includes heatshrink)
Connectors supplied 3x 3.5mm Female connectors fitted on the motor side


  • Easy setting, easy operation.
  • Safe start-up system. The motor will not start no matter which position the throttle stick is when the battery is connected.
  • Automatic power cut-off. If the motor suddenly stops rotating or the radio signal is lost for more than 3 seconds, the power will automatically be cut off.
  • BEC provides power to receiver and servos (for ESC with BEC).
  • High rate switching Pulse Width Modulation (PWM): 8KHZ.
  • Over-heat protection. The power will be cut-off as it is heated up to 110°C.
  • Over-voltage protection. The motor will not start if the voltage is higher than 18V (Expect for the OPTO series.)
  • Low-voltage cut-off. 3.0V/2.7V (selectable) for Li-ion/Li-polymer battery; or 0.9V/0.7V (selectable) for Ni-CD/Ni-MH battery.
  • Timing mode; Timing low mode--- providing highest efficiency suitable for motors with 2, 4, 6 poles; Timing high mode---providing highest speed & is suitable for motors with 6 or more poles and outrunner motors.
  • Programming is very easy with the programming card.

Part Number Description Price Qty
PP-TESC20AU 20A Brushless Electronic Speed Controller £13.95
PP-PROGCARD Programming Card £6.99

User Instructions

ESC Programming Instructions
How to wire up a UBEC

<<<  Back Top