 |
4-Max |
Est. 2007 |
||
| <<<
Back |
|
Tel:
01256 782 512 |
   |
|
128
Bit Secure ShoppingMini Servo Power Distribution Boxes
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
|
3 in 1 Digital CDI Switch, Heavy Duty Switch and Voltage Display |
|
|
|
|
|
Why Use a Mini Servo Power Distribution Box?
When using a large number of servos or a few high power digital servos the current needed to power these servos can be high, for example one single 16kg digital servo can draw up to 2.5A so you can see that it doesn't take many servos before very high current is needed to power all your servos. Receivers are not designed to handle such high current and you stand a real risk of damaging your receiver due to this high current and therefore loosing your large and expensive pride and joy.
The Mini Servo Power Distribution Box routes the current needed by your servos away from your receiver and through it's printed circuit board which is designed to handle currents as high as 30A making your system a lot safer.
The Mini Servo Power Distribution Box also allows you to use 2 separate batteries to power your receiver and servos giving you added safety should one battery fail while in flight.
It also allows for a very neat installation of up to 16 servos,
2 servos per channel.
Should the"ON/OFF" switch fail or become disconnected
in flight, the system will fail to"ON".
| Selection Chart | |||
| Feature | Green | Red | Yellow |
| Aircraft Type | Electric or Glow | Petrol 20cc - 50cc |
Petrol 20cc - 100cc |
| Battery I/P x2 | Yes | Yes | Yes |
| Number of Channels | 8 | 8+CDI Cut | 8+CDI Cut |
| Number of Servos | 16 | 16 | 16 |
| Switch fails to"ON" | Yes | Yes | Yes |
| OPTO Isolated CDI Cut circuit | No | Yes | Yes |
| CDI Output Status LED | No | Yes | Yes |
| Isolated receiver, servo, CDI circuits | N/A | No | Yes |
| Independent 5V linear voltage regulator for the receiver | No | No | Yes |
| 20A (30A Burst) UBEC to power Servos | No | No | Yes |
| ON/OFF Switch Supplied | Yes | Yes | Yes |
| Mounting Grommets and Screws Supplied | Yes | Yes | Yes |
| 3" Servo Connecting Leads Supplied | Yes | Yes | Yes |
| Approx Weight | 70g | 80g | 80g |
| Working Temp | -20℃ to 85℃ | -20℃ to 85℃ | -20℃ to 85℃ |
Please Note
If using 2 batteries, please make sure they are identical with
regards to:
type,
number of cells,
capacity ,
and most importantly
that they are the same voltage before connecting them both to the
Servo Power Distribution Box as any differences can result in a
large current transfer between the two batteries until their voltages
become equal, this high current could damage either the wiring
and/or the batteries themselves.